Oil-Filled 7-fin
Radiator Heater
OWNER’S MANUAL
Model # NDY-15
PLEASE SAVE THESE INSTRUCTIONS
WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.
NOT use on soft surfaces, like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where
gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit away
from heated surfaces and open flames.
13. Avoid the use of an extension cord because the extension cord may overheat and cause a
risk of fire. However, if you have to use an extension cord, the cord shall be No.14
AWG minimum size and rated not less than 1875W.
14. To avoid fire or shock hazard, plug the unit directly into a 115 V AC electrical outlet.
15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on
the plug, DO NOT unplug by pulling on the cord.
16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.
17. Use only for intended household use as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to persons.
The use of attachments not recommended or sold by unauthorized dealers may cause
hazards.
18. Always use on a dry, level surface. Use on floor only.
19. DO NOT use outdoors.
20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any
solid-state speed control device.
21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit.
Doing so will void your warranty. The inside of the unit contains no user serviceable
parts. Qualified personnel should perform all servicing only.
22. Connect to properly grounded outlets only.
23. SAVE THESE INSTRUCTIONS.
WARNING: This heater is equipped with a polarized plug (one blade is wider than the
other). The plug is intended to fit into a power outlet only one way, with the wide blade in
the wide slot. This is a safety feature, if you are unable to insert the plug fully into the
outlet, try reversing the plug. If the plug still does not fit, contact a qualified electrician.
DO NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED PLUG.
SPECIFICATIONS
Voltage Rating
Power Consumption
Unit Size
115 V (60Hz)
600/900/1500W
5.8 in. (W) x 15.2 in. (D) x 27.5 in. (H)
26 lbs
Unit Weight
PRODUCT DIAGRAM
ASSEMBLY
1. Remove the heater body, two wheelbases, and two U-shaped connecting screws with
wing nuts from the box. Remove the packaging materials and keep for future storage.
2. Be certain the heater is unplugged and the controls are set to off. Set the heater on the
floor upside down. The heater may make some noise as the liquid settles.
3. Remove the wing nuts from the U-shaped connecting screws. Place one of the U-shaped
connecting screws between the front two fins of the heater and over the joint so that the
threads on the screw project upward.
4. Insert the L-shaped end of the screw through one of the holes in the wheelbase. Slide the
threaded end through the other hole in the wheelbase.
5. Fasten the wing nut onto the screw securely.
6. Place the other U-shaped connecting screw between the back two fins of the heater and
repeat above procedure.
OPERATING INSTRUCTIONS
Place the heater on a firm, level surface and plug into a grounded 115V 60Hz power outlet. Only
operate heater in upright position with caster wheels attached. The heater features two power
switches with indicator lights and a thermostat control.
1. Select a heat setting.
For LOW heat (600W), press the switch on the left (I).
For MEDIUM heat (900W), press the switch on the right (II).
For HIGH heat (1500W), press both switches (I and II).
2. Turn the thermostat control clockwise as far as it will go. The indicator light on the
selected power switch will light.
3. Leave the thermostat control at its maximum setting until the desired temperature is
reached. Carefully lower the thermostat control by turning counter-clockwise until the
heater stops operating. The indicator light will shut off.
4. Leave thermostat control at this position. The heater will automatically cycle on and off
to maintain the chosen room temperature. The indicator lights will also turn and off to
indicate when the heater is operating.
5. Unplug the heater when not in use.
NOTE: For safety, if the heater’s internal temperature rises above a certain point, the heater
is designed to automatically shut off. Please wait about 20 minutes while the temperature of
the heater lowers, then heater will begin to work automatically.
WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit
between the outlet and the plug may cause overheating of the plug. If this occurs, try inserting
the plug into a different outlet. Contact a qualified electrician to inspect the original outlet for
damage.
MAINTENANCE
1. Unplug the unit and let it cool completely.
2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You
may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
CAUTION: DO NOT let liquid enter the heater.
3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to
clean the heater. This may cause damage or deterioration to the surface of the heater.
4. DO NOT immerse the heater in water.
5. Wait until the unit is completely dry before use.
STORAGE
Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the
original packaging to repack the unit.
TROUBLESHOOTING
If the heater will not operate, please check the following before seeking repair of service:
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.
2. Check if electricity to the main fuse is working.
3. Make certain the power switches are turned on. If not, choose a setting. Make certain the
thermostat control is turned on.
NOTE: The heater may not be operating if the thermostat control is set lower than the
room temperature. To begin operation, turn thermostat control to the right for a higher
heat setting.
SII0805
WARRANTY
One Year Limited Warranty
Soleus International Inc. warrants the accompanying Soleus Air NDY-15 to be free of defects in
material and workmanship for the applications specified in its operation instruction for a period
of ONE (1) year from the date of original retail purchase in the United States.
If the unit exhibits a defect in normal use, Soleus International Inc. will, at its option, either
repair or replace it, free of charge within a reasonable time after the unit is returned during the
warranty period.
As a condition to any warranty service obligation, the consumer must present this Warranty
Certificate along with a copy of the original purchase invoice.
THIS WARRANTY DOES NOT COVER:
1) Damage, accidental or otherwise, to the unit while in the possession of a consumer not
caused by a defect in material or workmanship.
2) Damage caused by consumer misuse, tampering, or failure to follow the care and special
handling provisions in the instructions.
3) Damage to the finish of the case, or other appearance parts caused by wear.
4) Damage caused by repairs or alterations of the unit by anyone other than those authorized
by Soleus International Inc.
5) Freight and Insurance cost for the warranty service.
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT
ABILITY ARE LIMITED TO ONE-YEAR DURATION OF THIS EXPRESS LIMITED
WARRANTY. SOLEUS INTERNATIONAL INC. DISCLAIMS ANY LIABILITY FOR
CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT SHALL SOLEUS
INTERNATIONAL INC’S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR
BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS
UNIT.
As some states do not allow the limitation or exclusion of incidental or consequential damages,
or do not allow limitation on implied warranties, the above limitations and exclusions may not
apply to you. This warranty gives you specific legal rights, and you may also have other rights
that vary from state to state.
For Warranty, Technical Support, Customer Service, Missing or Defective Parts
Please Call (888) 876-5387
Or Write To:
Soleus International Inc.
9451 Telstar Ave.
El Monte, CA 91731 USA
|