INSTALLATION GUIDE
SUBJECT: Stumpjumper Adjustable Dropout Installation
FROM: Engineering Department
DATE: 06/22/07
To ensure correct installation of the adjustable dropouts, please read and familiarize yourself
with the following steps:
Please read the following instructions. If you have any doubt regarding your mechanical ability and/or installation of
this product, visit your local authorized dealer. Specialized recommends that the dropouts be installed using a torque
wrench, by a qualified mechanic.
1
2
Stumpjumper
Left Dropout
9898-4230
Stumpjumper
Right Dropout
9898-4235
The bikes are equipped with one left and two right dropouts
(with and without the derailleur hanger tab). After-Market
dropouts are offered with the built-in derailleur hanger only
and can be used with gears or as a single-speed dropout.
Install the left and right dropouts. The threaded steel backing
plates are side-specific and must match the correct side dropouts.
Do not tighten the dropout bolts yet, leave them 1/4 turn loose.
NOTE: Make sure the bolt threads and washers are greased.
3
4
Install the rear wheel in the loose dropouts. Tightening the
quick-release will self-align the wheel and dropouts.
Install the disc brake.
ꢀ
|