MPS 800 Gateway Kit Installation
2
1
Use the rear panel power switch to
switch off the MPS power.
Insert the new Gateway board
into the first available slot in the front panel.
3
5
4
Connect a LAN cable from the Ethernet socket
of the board just installed and to your network.
Turn the MPS power back on.
Send the MPS serial No. to your TANDBERG
Representative. You will then receive the
option key needed to activate the new
boards.
6
Access the TANDBERG MPS by entering
the IP-address of the Gateway Board in
a standard web browser to complete the
configuration of the new Gateway Board and
upload the new Gateway option keys. See the
below Fig. and the MPS User Manual for more
information.
The system is ready for configuration once the
Power and the Active LED are green and the initial
configuration menu appears on the LCD.
Click the Restart button.
7
D13903.02
|